Thứ Bảy, 21 tháng 5, 2011

Pendant tutorial: orchid from polymer clay

(700x525, 127Kb)(700x525, 75Kb)


And it does not have to be a guru or have stotysch-hour experience with polymer clay.

We start with a picture of our petals.
I consulted with him and decided that I needed two colors: white and light pink.


(700x525, 98Kb)

Of white plastic, I form the "stump" and covered it with a ribbon, roll of pink plastic.


(700x525, 104Kb)

Further squeezed. Long uzhatuyu sausage cut. A third of tidy away. The remaining two-thirds rezhu on wedges (in my case it is 8 bars of equal length). Back to the lazy-thirds. I keep it stretched, and then cut so as to 8 identical in length bars.


(700x525, 107Kb)

Large wedges (in the sense of those that have a larger diameter), I flatten and stack up.


(700x525, 90Kb)

I spread over them wedges of smaller diameter.


(700x525, 72Kb)

Now I received a bar to shrink. But before I squeezed it all, I'll do one side of the bar more centered, larger than life figure for the petals.


(700x525, 80Kb)

Squeezed. And so what we do in the context of:


(700x525, 60Kb)

Now we begin to sculpt.
Cut plastic


(700x525, 90Kb)

Vyleplivayu flower petals.


(700x525, 103Kb)

Now the important point.
Our flower should be at the expense of something fixed.
What I do:
I take the patty and put plastic on her pre-bent pin (rigid wire), lightly press down.
You can see that outside of the "cake" I have a loop, for which I was then, and will strengthen the flower, and the cake itself - the hook. I do so in order to pin not taken off in the future. Due to hook our metal part is firmly in the flower.

(700x525, 93Kb)

Begin to spread the petals

(700x525, 109Kb)

And pressed down from a toothpick to the bottom of the flower (the same cake)


(700x525, 103Kb)


(700x525, 82Kb)

At its discretion, attach petals rippling, helping himself with a toothpick.


(700x525, 91Kb)
(700x525, 102Kb)

The last remaining petal. I call it "skirt", and someone calls a "beard":)


(700x525, 92Kb)
(700x525, 87Kb)
(700x525, 92Kb)

Remains to be done "nose" - and ready:)
I rolled a small piece of plastic, giving it a drop-shaped


(700x525, 83Kb)

Place it in the opposite direction from the "skirt" and just press down with a toothpick.


(700x525, 77Kb)

and then gently bend it toward a "skirt"


6 863 (700x525, 86 Kb)
(700x525, 76Kb)

The flower is ready:)
Now, stand it on a surface on which it is baked. In my case it's a piece of cardboard. Baking temperature - 130 degrees, baking time - 25 minutes.


(700x525, 120Kb)

After baking - varnish (not so much shine, but in order to secure the bright flower of dirt and dust). Pendant is ready:)


(700x525, 75Kb)

If someone remembers, then on the same principle I have already made pendants, orchids year ago:


(700x525, 107Kb)

Socializer Widget By Blogger Yard
SOCIALIZE IT →
FOLLOW US →
SHARE IT →

0 nhận xét:

Đăng nhận xét